NIGHT VISION II - Multitool knife VICTORINOX SWISS ARMY - Free user manual and instructions

USER MANUAL NIGHT VISION II VICTORINOX SWISS ARMY

The Night Vision II watch makes use of Light Emitting Diode (LED) for its flashlight and soft dial lighting. LEDs last longer than conventional incandescent bulbs, and are more durable and energy-efficient.

Please note that the battery life of the lighting functions is significantly reduced with greater use.

Pusher for Lighting Functions

SETTING THE DATE AND THE TIME

PULL-OUT CROWN

A. Pull out the crown to the middle position (2).
B. Turn the crown away from you until the date showing is the day before the desired setting.
C. Pull out the crown to the fully extended position (3) and rotate toward you. When midnight is reached, the date will advance to the desired date. Continue to turn the crown until the desired time is set. Remember that the date advances at 12.00 midnight not 12.00 noon.
D. Push back the crown in to its normal position (1). The date and the time are now set.

TO SET TIME ALONE: Refer to instructions "C".

LIGHTING FUNCTIONS

1. Dial Illumination Mode

One quick push of the pusher will activate the soft blue LED light. The angle of the light directs it to reflect off the crystal for maximum visibility of the dial and hands.

Note: During the Dial Illumination Mode, please note that the other lighting functions (2-3-4) cannot be activated.

2. Extended Light Mode

Two quick pushes of the pusher activates the white LED. Light will automatically deactivate after 2 minutes, or you can turn light off by pressing the pusher once.

3. Signal Mode

Three quick pushes of the pusher will cause the white LED light to strobe (150 p/min.) for 2 minutes. To deactivate prior 2 minutes, press pusher once.

4. Intense Signal Mode

Holding the pusher for 5 seconds will activate an intensified LED strobe that flashes continuously. Intense signal mode is brighter than normal Signal Mode flashing (60 p/min.). To deactivate, press pusher for 5 seconds.

5. Locator Mode

Red LED locator beacon is positioned at the 6 o'clock marker and blinks once every 10 seconds. An easy way to find your timepiece.

6. Battery End of Life Mode (EOL)

Red LED locator beacon positioned at the 6 o'clock marker will flash 3 times every 10 seconds indicating lighting batteries should be changed.

7. Battery Consumption

Your Night Vision II timepiece has a built-in feature to protect battery consumption if the pusher used to operate the LED is accidentally pressed (for example in luggage or coat pocket, etc.). If the pusher is pressed for more than 30 consecutive seconds, the lighting feature will shut off automatically.

WATER RESISTANCE

Please check the indication of water resistance on the case back of your Victorinox Swiss Army watch and carefully read the corresponding explanation from the following list:

Water-resistant to 30 meters (100 feet/3 ATM). Will withstand rain or splashes of water but should not be worn while showering, swimming or diving.

Water-tested to 50 meters (165 feet/5 ATM).Suitable for showering or swimming in shallow water.

Water-tested to 100 meters (330 feet/10 ATM). Suitable for swimming or snorkeling.

Water-tested to 200 meters (660 feet/20 ATM). Suitable for swimming, snorkeling or skin diving.

Water-tested to 300 meters (990 feet/30 ATM). Suitable for swimming, snorkeling or scuba diving.

Water-tested to 500 meters (1,650 feet/50 ATM). Suitable for swimming, snorkeling or scuba diving.

BATTERY

Lighting - The lighting module of your Night Vision II watch operates off of a separate battery power source (1 battery cell - 3 volt Lithium batteries CR 2032).

Watch Movement - The watch movement is powered by a 1.55 volt silver oxide watch battery. When the battery is low, the second hand will effect four second jumps. Worn Batteries should be replaced immediately. It is recommended to use original batteries. Battery change should be performed by a qualified technician who should also check the condition of the gaskets at the same time. Battery is not covered by the warranty.

Please use an authorized Victorinox Swiss Army service center in the event either the light module or watch battery requires replacement.